NEW QUESTION 1

Which router attaches the VPN label to incoming packets from CE routing?

• A. CE router
• B. core router
• C. P router
• D. PE router

Answer: D

NEW QUESTION 2



Refer to the exhibit. Which configuration resolves the route filtering issue on R1 to redistribute all the routes except 172.16.2.48/28?
A)

B)

C)

D)

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: D

NEW QUESTION 3


Refer to the exhibit. R1 and R2 cannot establish an EIGRP adjacency. Which action establishes EIGRP adjacency?

• A. Remove the current autonomous system number on one of the routers and change to a different value.
• B. Remove the passive-interface command from the R2 configuration so that it matches the R1 configuration.
• C. Add the no auto-summary command to the R2 configuration so that it matches the R1 configuration.
• D. Add the passive-interface command to the R1 configuration so that it matches the R2 configuration.

Answer: B

NEW QUESTION 4

Refer to the exhibit.

Which configuration configures a policy on R1 to forward any traffic that is sourced from the 192.168.130.0/24 network to R2?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: D

NEW QUESTION 5

Refer to the exhibit.

Which interface configuration must be configured on the HUB router to enable MVPN with mGRE mode?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-mt/sec-conn-dmvpn-15-m

NEW QUESTION 6


Refer to the exhibit. An engineer configured route exchange between two different companies for a migration project EIGRP routes were learned in router C but no OSPF routes were learned in router A. Which configuration allows router A to receive OSPF routes?

• A. (config-router-af)#redistribute ospf 10 1000000 10 255 1 1500
• B. (config-routeraf-topology)#redistribute ospf 10 metric 1000000 10 255 1 1500
• C. (config-router-af-topology)#redistribute connected
• D. (config-router-af-topology )£no redistribute ospf 10 match external 1 external 2 metric 1000000 10 2551 1500

Answer: B

NEW QUESTION 7


Refer to the exhibit. The client server but the show command does not show the IPv6 DHCP bindings on the server. Which action resolves the issue?

• A. Extend the DHCP lease time because R1 removed the IPv6 address earlier after the lease expired.
• B. Configure H1 as the DHCP client that manually assigns the IPv6 address on interlace e0/0..
• C. Use the 2001:DBB:BAD:C0DE::/64 prefix for the DHCP pool on R1.
• D. Configure authorized DHCP servers to avoid IPv6 addresses from a rogue DHCP server.

Answer: C

NEW QUESTION 8

Refer to the exhibit.

To provide reachability to network 10.1.1.0 /24 from R5, the network administrator redistributes EIGRP into OSPF on R3 but notices that R4 is now taking a ........... path through R5 to reach 10.1.1.0/24 network. Which action fixes the issue while keeping the reachability from R5 to 10.1.1.0/24 network?

• A. Change the administrative distance of the external EIGRP to 90.
• B. Apply the outbound distribution list on R5 toward R4 in OSPF.
• C. Change the administrative distance of OSPF to 200 on R5.
• D. Redistribute OSPF into EIGRP on R4

Answer: A

NEW QUESTION 9


Refer to the exhibit. Which configuration resolves the IP SLA issue from R1 to the server?

• A. R6(config)#ip sla responder
• B. R6(config)#ip sla responder udp-echo ipaddress 10.60.60.6 po 5000
• C. R6(config)#ip sla 650 R6(config-ip-sla)ff udp-jitter 10.60.60.6
• D. R6(config)#ip sla schedule 10 life forever start-time now

Answer: A

NEW QUESTION 10

Refer to the exhibit. An engineer is trying to log in to R1 via R3 loopback address. Which action resolves the issue?

• A. Add transport input SCP
• B. Add transport input none
• C. Remove the IPv6 traffic filter from R1, which is blocking the Telnet.
• D. Remove the IPv6 traffic from R1, which is blocking the SSH

Answer: C

NEW QUESTION 11

Refer to the exhibit. The ISP router is fully configured for customer A and customer B using the VRF-Lite feature. What is the minimum configuration required for customer A to communicate between routers A1 and A2?

• A. A1interface fa0/0 description To->ISPip add 172.31.100.1 255.255.255.0no shut!router ospf 100net 172.31.100.1 0.0.0.255 area 0 A2interface fa0/0 description To->ISPip add 172.31.200.1 255.255.255.0no shut!router ospf 100net 172.31.200.1 0.0.0.255 area 0
• B. A1interface fa0/0 description To->ISP ip vrf forwarding Aip add 172.31.100.1 255.255.255.0no shut!router ospf 100net 172.31.100.1 0.0.0.255 area 0 A2interface fa0/0 description To->ISP ip vrf forwarding Aip add 172.31.200.1 255.255.255.0no shut!router ospf 100net 172.31.200.1 0.0.0.255 area 0
• C. A1interface fa0/0 description To->ISPip add 172.31.200.1 255.255.255.0no shut!router ospf 100net 172.31.200.1 0.0.0.255 area 0 A2interface fa0/0 description To->ISPip add 172.31.100.1 255.255.255.0no shut!router ospf 100net 172.31.100.1 0.0.0.255 area 0
• D. A1interface fa0/0 description To->ISP ip vrf forwarding Aip add 172.31.100.1 255.255.255.0no shut!router ospf 100 vrf Anet 172.31.200.1 0.0.0.255 area 0 A2interface fa0/0 description To->ISP ip vrf forwarding Aip add 172.31.100.1 255.255.255.0no shut!router ospf 100 vrf Anet 172.31.200.1 0.0.0.255 area 0

Answer: C

Explanation:
A1 and A2 routers do not know they belong to VRF A. The two
interfaces of ISP (which are connected to A1 & A2) should be configured like this (we only show the configure of one interface):
ISP router:
interface g0/0
description ISP->To_CustomerA ip vrf forwarding A
ip address 172.31.100.2 255.255.255.0
router ospf 100 vrf A
network 172.31.200.2 0.0.0.255 area 0

NEW QUESTION 12

Refer to the exhibit.

A NOC team receives a ticket that data traffic from RA to RF is not forwarded when the link between the RC-RE path goes down. All routers learn loopback IP through the IGP protocol. Which configuration resolves?

• A. RD(config)#router bgp B5201RD(config-router)# neighbor 10.10.10.2 update-source loopback 0
• B. RD(config-router)# neighbor bgp 65101RB(config-router)# neighbor 10.10.10.3 ebgp-multihop 3
• C. RB(config)# router bgp 65101RB(config)#neighbor 10.10.10.3 update-source loopback 0
• D. RD(config)# router bgp 65201RDI(config-router)# neighbor 10.10.10.2 ebgp-multihop 3

Answer: B

NEW QUESTION 13

An engineer configured routing between multiple OSPF domains and introduced a routing loop that caused network instability. Which action resolves the problem?

• A. Set a tag using the redistribute command toward a domain and deny inbound m the other domain by a matching tag
• B. Set a tag using the redistribute command toward a different domain and deny the matching tag when exiting from that domain
• C. Set a tag using the network command in a domain and use the route-map command to deny the matching lag when exiting toward a different domain
• D. Set a tag using the network command in a domain and use the route-map command to deny the matching tag when entering into a different domain

Answer: A

NEW QUESTION 14

Refer to Exhibit.

A network administrator enables DHCP snooping on the Cisco Catalyst 3750-X switch and configures the uplink port (Port-channel2) as a trusted port. Clients are not receiving an IP address, but when DHCP snooping is disabled, clients start receiving IP addresses. Which global command resolves the issue?

• A. No ip dhcp snooping information option
• B. ip dhcp snooping
• C. ip dhcp relay information trust portchannel2
• D. ip dhcp snooping trust

Answer: A

NEW QUESTION 15

Refer to the exhibit.

Users in VLAN46 cannot get the IP from the DHCP server. Assume that all the parameters are configured properly in VLAN 10 and on the DHCP server Which command on interlace VLAN46 allows users to receive IP from the DHCP server?

• A. ip dhcp-addreos 10.221.10.10
• B. ip dhcp server 10.221.10.10
• C. ip helper-addrets 10.221.10.10
• D. ip dhcp relay information trust-all

Answer: C

NEW QUESTION 16

Which two statements about redistributing EIGRP into OSPF are true? (Choose two)

• A. The redistributed EIGRP routes appear as type 3 LSAs in the OSPF database
• B. The redistributed EIGRP routes appear as type 5 LSAs in the OSPF database
• C. The administrative distance of the redistributed routes is 170
• D. The redistributed EIGRP routes appear as OSPF external type 1
• E. The redistributed EIGRP routes as placed into an OSPF area whose area ID matches the EIGRPautonomous system number
• F. The redistributed EIGRP routes appear as OSPF external type 2 routes in the routing table

Answer: BF

NEW QUESTION 17

The network administrator configured the router for Control Plane Policrg so that inbound SSH traffic is policed to 500 kbps This policy must apply to traffic coming in from 101010 0<24 and 192 168 10.0/24 networks

The Control Rane Policing is not applied to SSH traffic and SSH is open to use any bandwidth available. Which configuration resolves this issue?


A)

B)

C)

D)

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 18
......