NEW QUESTION 1

Refer to the exhibit.

Router R14 is in the process of being configured. Which configuration must be used to establish a host route to PC 10?

• A. ip route 10.80.65.10 255.255.255.254 10.80.65.1
• B. ip route 10.8065.10 255.255.255.255 10.73.65.66
• C. ip route 1073.65.65 255.0.0.0 10.80.65.10
• D. ip route 10.73.65.66 0.0.0.255 10.80.65.10

Answer: B

NEW QUESTION 2

Why is a first-hop redundancy protocol implemented?

• A. to protect against default gateway failures
• B. to prevent loops in a network
• C. to enable multiple switches to operate as a single unit
• D. to provide load-sharing for a multilink segment

Answer: A

NEW QUESTION 3

Which CRUD operation corresponds to the HTTP GET method?

• A. read
• B. update
• C. create
• D. delete

Answer: A

Explanation:
GET: This method retrieves the information identified by the request URI. In the context of the RESTful web services, this method is used to retrieve resources. This is the method used for read operations (the R in CRUD).
https://hub.packtpub.com/crud-operations-rest/

NEW QUESTION 4
DRAG DROP
Drag and drop the device behaviors from the left onto the matching HSRP slate on the right.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 5

Where is the interface between the control plane and data plane within the software- defined architecture?

• A. control layer and the infrastructure layer
• B. application layer and the infrastructure layer
• C. control layer and the application layer
• D. application layer and the management layer

Answer: A

NEW QUESTION 6
DRAG DROP
Drag and drop the wireless architecture benefits from the left onto the architecture types on the right.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 7
DRAG DROP
Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 8

Refer to the exhibit.

An engineer is updating the management access configuration of switch SW1 to allow secured, encrypted remote configuration. Which two commands or command sequences must the engineer apply to the switch? (Choose two.)

• A. SW1(config)#enable secret ccnaTest123
• B. SW1(config)#username NEW secret R3mote123
• C. SW1(config)#line vty 0 15 SW1(config-line)#transport input ssh
• D. SW1(config)# crypto key generate rsa
• E. SW1(config)# interface f0/1 SW1(confif-if)# switchport mode trunk

Answer: CD

NEW QUESTION 9

What is the functionality of the Cisco DNA Center?

• A. data center network pokey con
• B. console server that permits secure access to all network devices
• C. IP address cool distribution scheduler
• D. software-defined controller for automaton of devices and services

Answer: D

NEW QUESTION 10

Which two outcomes are predictable behaviors for HSRP? (Choose two)

• A. The two routers share a virtual IP address that is used as the default gateway for devices on the LAN.
• B. The two routers negotiate one router as the active router and the other as the standby router
• C. Each router has a different IP address both routers act as the default gateway on the LAN, and traffic is load balanced between them.D The two routers synchronize configurations to provide consistent packet forwarding
• D. The two routed share the same IP address, and default gateway traffic is load-balanced between them

Answer: AB

NEW QUESTION 11


A)

B)

C)

D)

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 12

Which set of 2.4 GHz nonoverlapping wireless channels is standard in the United States?

• A. channels 2, 7, 9, and 11
• B. channels 1, 6, 11, and 14
• C. channels 2, 7, and 11
• D. channels 1, 6, and 11

Answer: D

Explanation:
In the United States, while channels 1-13 can be used for 2.4 GHz WiFi, only three channels are considered non-overlapping (channels 12 and 13 are allowed under low powered conditions, but for most cases are not used). For best results, it is highly recommended to keep the 2.4 GHz channels to 1, 6, and 11, as these channel settings will allow for virtually no overlap in the WiFi signal. Shown below is a channel graph from WiFi Scanner showing three access points configured for channels 1, 6, and 11. As you can see, the center of each signal is at 1, 6, and 11 with the actual signal extending over several channels to the left and right.

NEW QUESTION 13

The service password-encryption command is entered on a router. What is the effect of this configuration?

• A. restricts unauthorized users from viewing clear-text passwords in the running configuration
• B. encrypts the password exchange when a VPN tunnel is established
• C. prevents network administrators from configuring clear-text passwords
• D. protects the VLAN database from unauthorized PC connections on the switch

Answer: A

NEW QUESTION 14

Which QoS tool is used to optimize voice traffic on a network that is primarily intended for data traffic?

• A. FIFO
• B. WFQ
• C. PQ
• D. WRED

Answer: C

NEW QUESTION 15
DRAG DROP
Drag and drop the characteristic from the left onto the IPv6 address type on the right.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 16

What is the role of disaggregation in controller-based networking?

• A. It divides the control-plane and data-plane functions.
• B. It summarizes the routes between the core and distribution layers of the network topology.
• C. It enables a network topology to quickly adjust from a ring network to a star network
• D. It streamlines traffic handling by assigning individual devices to perform either Layer 2 or Layer 3 functions.

Answer: A

NEW QUESTION 17

What is the default port-security behavior on a trunk link?

• A. It causes a network loop when a violation occurs.
• B. It disables the native VLAN configuration as soon as port security is enabled.
• C. It places the port in the err-disabled state if it learns more than one MAC address.
• D. It places the port in the err-disabled slate after 10 MAC addresses are statically configured.

Answer: A

NEW QUESTION 18

What is a function of a Layer 3 switch?

• A. move frames between endpoints limited to IP addresses
• B. transmit broadcast traffic when operating in Layer 3 mode exclusively
• C. forward Ethernet frames between VLANs using only MAC addresses
• D. flood broadcast traffic within a VLAN

Answer: A

NEW QUESTION 19

Which WAN topology provides a combination of simplicity quality, and availability?

• A. partial mesh
• B. full mesh
• C. point-to-point
• D. hub-and-spoke

Answer: C

NEW QUESTION 20
......