NEW QUESTION 1

What is a reason to configure a trunk port that connects to a WLC distribution port?

• A. Eliminate redundancy with a link failure in the data path.
• B. Allow multiple VLAN to be used in the data path.
• C. Provide redundancy if there is a link failure for out-of-band management.
• D. Permit multiple VLANs to provide out-of-band management.

Answer: D

NEW QUESTION 2

Refer to the exhibit.

An engineer configured the New York router with state routes that point to the Atlanta and Washington sites. When command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?

• A. ipv6 route ::/0 Serial 0/0/1
• B. ipv6 route 0/0 Serial 0/0/0
• C. ipv6 route ::/0 Serial 0/0/0
• D. ip route 0.0.0.0.0.0.0.0 Serial 0/0/0
• E. ipv6 route ::/0 2000::2

Answer: C

NEW QUESTION 3
DRAG DROP
Drag and drop the characteristic from the left onto the IPv6 address type on the right.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 4

An organization secures its network with multi-factor authentication using an authenticator app on employee smartphone. How is the application secured in the case of a user’s smartphone being lost or stolen?

• A. The application requires an administrator password to reactivate after a configured Interval.
• B. The application requires the user to enter a PIN before it provides the second factor.
• C. The application challenges a user by requiring an administrator password to reactivate when the smartphone is rebooted.
• D. The application verifies that the user is in a specific location before it provides the second factor.

Answer: B

NEW QUESTION 5
DRAG DROP
Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 6

What is a similarity OM3 and OM4 fiber optical cable?

• A. Both have a 62.5 micron core diameter.
• B. Both have a 50 micron core diameter.
• C. Both have a 100 micron core diameter.
• D. Both have a 9 micron core diameter.

Answer: B

NEW QUESTION 7

Refer to the exhibit.

Which prefix does Router 1 use for traffic to Host A?

• A. 10.10.10.0/28
• B. 10.10.13.0/25
• C. 10.10.13.144/28
• D. 10.10.13.208/29

Answer: D

Explanation:
Host A address fall within the address range. However, if more than one route to the same subnet exist (router will use the longest stick match, which match more specific route to the subnet). If there are route 10.10.13.192/26 and 10.10.13.208/29, the router will forward the packet to /29 rather than /28.

NEW QUESTION 8

Refer to the exhibit.

The loopback1 interface of the Atlanta router must reach the lookback3 interface of the Washington router.

• A. ipv6 route 2000::1/128 2012::2
• B. ipv6 route 2000::1/128 2012::1
• C. ipv6 route 2000:3 123 s0/0/0
• D. ipv6 route 2000::3/128 2023::3
• E. ipv6 route 2000::1/128 s0/0/1

Answer: BD

NEW QUESTION 9

Refer the exhibit.

What is the cause of poor performance on router R19?

• A. excessive collisions
• B. speed and duplex mismatch
• C. port oversubscription
• D. excessive CRC errors

Answer: A

NEW QUESTION 10

What is a DHCP client?

• A. a workstation that requests a domain name associated with its IP address
• B. a host that is configured to request an IP address automatically
• C. a server that dynamically assigns IP addresses to hosts.
• D. a router that statically assigns IP addresses to hosts.

Answer: B

NEW QUESTION 11

How are VLAN hopping attacks mitigated?

• A. enable dynamic ARP inspection
• B. manually implement trunk ports and disable DTP
• C. activate all ports and place in the default VLAN
• D. configure extended VLANs

Answer: B

NEW QUESTION 12

Which type of encryption does WPA1 use for data protection?

• A. AES
• B. TKIP
• C. PEAP
• D. EAP

Answer: B

NEW QUESTION 13

How does MAC learning function on a switch?

• A. broadcasts frames to all ports without queueing
• B. adds unknown source MAC addresses to the address table
• C. sends a retransmission request when a new frame is received
• D. sends frames with unknown destinations to a multicast group

Answer: B

NEW QUESTION 14

Refer to the exhibit.

An engineer is configuring the HO router. Which IPv6 address configuration must be applied to the router fa0'1 interface for the router to assign a unique 64-brt IPv6 address to Itself?

• A. ipv6 address 2001:DB8:0:1:C601:42FF:FE0F:7/64
• B. ipv6 address 2001:DB8:0:1:C601:42FE:800F:7/64
• C. ipv6 address 2001 :DB8:0:1:FFFF:C601:420F:7/64
• D. iov6 address 2001 :DB8:0:1:FE80:C601:420F:7/64

Answer: A

NEW QUESTION 15
DRAG DROP
Drag and drop the Rapid PVST+ forwarding slate actions from the loft to the right. Not all actions are used.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 16

What Is a syslog facility?

• A. Host that is configured for the system to send log messages
• B. password that authenticates a Network Management System to receive log messages
• C. group of log messages associated with the configured severity level
• D. set of values that represent the processes that can generate a log message

Answer: C

Explanation:
Cisco Community – Difference between logging level and logging facility Post by ahmednaas
“The logging facility command basically tells the syslog server where to put the log message. You configure the syslog server with something like:
local7.debug /var/adm/local7.log
Now, when you use the “logging facility local7” on your device, all messages with severity “debug” or greater should be saved in /var/adm/local7.log.”
Example: on a switch, any process (CDP, SNMP, etc.) can generate a log message. On a syslog server, the logging facility is the place where all received messages with the same priority level are stored.

NEW QUESTION 17

What are two roles of Domain Name Services (DNS)? (Choose Two)

• A. builds a flat structure of DNS names for more efficient IP operations
• B. encrypts network Traffic as it travels across a WAN by default
• C. improves security by protecting IP addresses under Fully Qualified Domain Names (FQDNs)
• D. enables applications to identify resources by name instead of IP address
• E. allows a single host name to be shared across more than one IP address

Answer: DE

NEW QUESTION 18

Refer to the exhibit.

PC1 regularly sends 1800 Mbps of traffic to the server. A network engineer needs to configure the EtherChannel to disable Port Channel 1 between SW1 and SW2 when the Ge0/0 and Ge0/1 ports on SW2 go down. Which configuration must the engineer apply to the switch?
A)

B)

C)

D)

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: D

NEW QUESTION 19

An engineer must configure neighbor discovery between the company router and an ISP

What is the next step to complete the configuration if the ISP uses a third-party router?

• A. Enable LLDP globally.
• B. Disable CDP on gi0/0.
• C. Enable LLDP TLVs on the ISP router.
• D. Disable auto-negotiation.

Answer: A

NEW QUESTION 20
......